EN
37
4. Press the pushbuttons UP and MENU at the same time for at least 5 seconds until LOP is displayed,
then (if necessary) press DOWN (see gure).
Ensure that motor M1 opens rst; otherwise, press DOWN, turn the power o and invert connections M1
and M2. Repeat the procedure from step 4.
If the rst manoeuvre is NOT opening, press DOWN to stop the self-learning process. Then press SBS
to restart acquisition: the leaf resumes movement in the correct direction
M1
SBS
M2
4
5. Motor M1 opens at low speed until it reaches the mechanical opening end stop.
On reaching the mechanical end stop on opening of M1 motor M2 starts automatically in opening mode
(the display shows LO.P.). If motor M2 moves in closing, stop by pressing DOWN and resume movement
using SBS (the leaf resumes movement in the correct direction)
M1
SBS
M2
5
6. The motor M2 opens at low speed until reaching the mechanical opening end stop. After a couple of
seconds, the motor M2 closes at low speed (the display shows LC.L.)
M1 M2 6
7. On reaching the point where motor M2 closing deceleration is required, press SBS. M2 motor
movement continues at low speed (the display shows SC.L.)
M1
M2
SBS
7
8. On reaching the mechanical end stop of motor M2, motor M1 starts closing
M1
M2
8
9. On reaching the point where motor M1 closing deceleration is required, press SBS. M1 motor
movement continues at low speed (the display shows SCL)
M1 M2
SBS
9
10. When motor M1 reaches the closed position, motor M1 stops and restarts in opening
M1 M2
10
11. On reaching the point where motor M1 opening deceleration is required, press SBS. M1 motor
movement continues at low speed (the display shows SOP)
M1 M2
SBS
11
12. When motor M1 reaches the open position, motor M1 stops and motor M2 starts in opening
M1
M2
12
13. On reaching the point where motor M2 opening deceleration is required, press SBS. M2 motor
movement continues at low speed. (the display shows SO.P.)
M1
M2
SBS
13
14. When motor M2 reaches the open position, motor M2 stops
M1 M2 14
15. M1 and M2 resume closing according to the oset parameter entered in the menu, i.e. the gate
closes automatically according to the set travel
M1 M2 15
16. Run a number of opening, closing and stop manoeuvres, to check that the system is stable and there
are no assembly defects.
The deceleration points not assigned manually will be automatically set at 20% of the control unit stroke
To Next Page
Loading...