19
MOUNTING
3M™ DUAL LOCK™ ADHESIVE STRIPS
Ensure both the back of the Callbox and the
area of the surface that is being attached to
is clean, flat, and dry.
Peel off one side of the DualLock’s release
backing and firmly adhere to the left side of
the unit. Repeat this with the other DualLock
to the right side of the Callbox.
Once both strips of DualLock are attached
to the Callbox, peel off the white release
backing and carefully align the unit to be
level on the surface you intend to place it.
Once the Callbox appears aligned, firmly
press it to the wall in one motion.
NOTE: The Callbox can be removed by
applying firm pressure around the exterior
edge of the unit.
To Next Page
Loading...
Need help?
General
