35
CALL CYCLES
CALL CYCLES
Press the or button until the Call
Cycles? menu is shown. Press the ENTER
button to begin the next step.
Use the or buttons to increase/de-
crease the Call Cycle selection. The range is
1-30 cycles.
Press-and-Hold the or button for faster
increments.
Press ENTER to select the new Call Cycle, or
to exit without any changes.
Call Cycles?
Old: 2 cycles
New: 2 cycles
The total Call Cycles refer to the repeating RF broadcasts that will occur when the call button (or
aux) button is activated. The system will automatically clear an active call when the Total Call
Cycle value is reached. System Default: 2 cycles
NOTE: Special Menus must be enabled to view this selection.
To Next Page
Loading...
Need help?
General
