Kit (Part Number) Description
NNTN9089 IMPRES 2 Li-Ion IP68 5650 mAh
NNTN9090 IMPRES 2 Li-Ion DIV2 (HAZLOC) IP68 5650 mAh
NNTN9126 IMPRES 2 Li-Ion IP68 4400 mAh
NNTN9127 IMPRES 2 Li-Ion DIV2 (HAZLOC) IP68 4400 mAh
PMNN4812 APX NEXT XN IMPRES 2 Li-Ion DIV 2 (HAZLOC) IP68 3400 mAh
2.6
Charger, Pocket, and Communications Module
The APX-Series IMPRES 2 Adaptive Charger System is a fully automated battery care system. The charger
is equipped with the following features:
● Adaptive charging to accommodate a wide variety of battery types, including IMPRES 2, IMPRES, and
other authentic Motorola Solutions batteries.
● Pocket that accommodates either a stand-alone battery or a radio with attached battery.
● Red/Amber/Green LED indicating charger pocket status.
● Communications Module:
○ Charger reprogramming
○ IMPRES 2 or IMPRES battery data upload to an IMPRES Battery Fleet Management System.
○ (Optional) Six USB Type A charging ports, each with 0.5A for charging of a USB accessory
● Keypad Menu
○ Charger Setup
○ Battery Analysis
● Information Display on Pocket #1
○ Optional displays on other pockets
● Preparation of a stand-alone IMPRES 2 or IMPRES battery for long-term storage or preparation of a
stand-alone Motorola Solutions Lithium-Ion battery for shipment. DO NOT leave batteries in the charger
after preparation for Long-Term Storage or Lithium-Ion Shipment is complete.
● Energy-Efficiency Features
○ Compliant with the California Energy Commission appliance standards for small battery charging
systems. The charger pockets automatically sleep, then wake to respond to user action or to service
a battery in the pocket.
○ Compliant with the European Standby Current Limits (European Charger Kit). When Power Saver
Mode is enabled, all charger pockets, except Pocket #1, turn off automatically when there is no
activity for a period of time. Pressing any Keypad button turns these pockets back on.
● Higher-rate IMPRES 2 Lithium-Ion battery charging
● Faster charging
● Extended battery life cycle
Operation of a radio while it is in the charger is not recommended.
During the charging process, radio operation may result in minimally reduced radio performance and
extended battery charge time.
MN002407A01-AK
Chapter 2: Operational Safety Guidelines
14
To Next Page
Loading...
