EasyManua.ls Logo

Motorola solutions IMPRES 2 - Charging Indications for IMPRES 2 or IMPRES Battery Calibration (Calibration Initially Disabled, Then Enabled)

Motorola solutions IMPRES 2
1005 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Status Pocket Display LED Indicator
recommends removing from
fleet):
NOTE: Applicable on-
ly for APX NEXT XN
battery.
Fault WARNING:
NOT CHARGEABLE
REMOVE & REINSERT
Flashing red
Standby
Battery is waiting to rapid
charge.
Battery is too hot, too
cold, or low voltage.
Charger is too hot.
WARNING:
HOT BATTERY
WAITING TO CAL
OR
COLD BATTERY
WAITING TO CAL
OR
VERY LOW BATTERY
WAITING TO CHRGE
OR
HOT CHARGER
WAITING TO CAL
Flashing amber
Table 9: Charging Indications for IMPRES 2 or IMPRES Battery Calibration (Calibration Initially
Disabled, Then Enabled)
Status Pocket Display LED Indicator
Charger Powers On
IMPRES 2
CHARGER
Green for approximately 1 sec-
ond
Battery Detected
IMPRES 2
BATTERY
OR
IMPRES
BATTERY
Battery requires Calibration,
but Calibration is disabled in
charger.
Alternating amber and green
for four seconds.
Requesting IMPRES Battery
Calibration
Calibration is disabled in
charger.
Battery is charging.
WARNING:
ENABLE BATTERY
CALIBRATION?
NOTE: Press OK to enable
calibration and ignore for
normal charging. Message is
removed after 1 minutes.
Steady red
MN002407A01-AK
Chapter 5: Charging Indication
27

Table of Contents

Related product manuals