Motorola solutions L5Q - Setting the Camera Date and Time from Reconyx Connect; Figure 9: Connecting the Battery Terminal

Figure 9: Connecting the Battery Terminal
4 Replace and tighten the bolt on the rear of the solar panel.
2.6
Setting the Camera Date and Time
NOTICE: For firmware version 0224a and application version 1.1.0, the camera date and time
can also be set remotely from the Reconyx Connect application.
Procedure:
1 Perform one of the following actions:
• Open the camera and install 12 AA Lithium Ion Batteries.
• Connect the camera to the Solar Panel with the power cable.
NOTICE: If you are connecting the camera to the Solar Panel, do not install the 12 AA
batteries. Place the included desiccant pack into the battery compartment to protect it
from moisture.
2 To power on the camera, slide up the power switch to the right of the LED display.
3 Press the Right button to scroll through the menu options to CHANGE SETUP.
4 Press OK.
5 Press the Right button to scroll to DATE/TIME.
6 Press OK.
7 Press Up or Down button to change numbers and Right or Left button to scroll through settings
for year, month, date, and time accordingly.
8 Press OK to exit.
9 Power off the camera.
10 Remove power cable from camera if plugged in.
2.6.1
Setting the Camera Date and Time from Reconyx Connect
Prerequisites:This procedure is only working with a firmware version 0224a or later and application
version 1.1.0 or later.
MN007598A01-AD
Chapter 2 : Getting Started
14