Option Actions
Figure 11: Mounting the Solar Panel to a Pole
Mounting the solar panel
to a flat wooden surface.
a Mount the solar panel mounting bracket to the wooden
surface using the Lag Bolts and Impact Wrench or a Sock-
et Wrench.
b Hang the solar panel on the bracket.
Figure 12: Mounting the solar panel to a Flat Wooden
Surface
3.3
Mounting the Security Enclosure
Procedure:
Perform one of the following actions:
Option Actions
Mounting the security en-
closure to a pole.
a Insert two Hose Clamps through the two sets of slots in
the Security Enclosure Mounting Bracket.
b Mount the Security Enclosure Mounting Bracket to the
pole with the Hose Clamps . Tighten the clamps with the 5
mm Hex Key.
c Reinsert the ball on the rear portion of the Security Enclo-
sure into the Security Enclosure Mounting Bracket and
tighten the ball lock to secure it.
d Plug in the female barrel connector of the power cable to
the rear of the Solar Panel.
MN007598A01-AD
Chapter 3 : Hardware Installation
17
To Next Page
Loading...
