Chapter 5
Application Configuration
This section provides the instructions to adjust the image capture by using the Reconyx Connect
application.
5.1
Shifting the Image
Prerequisites:Depending on camera placement, the image may need shifting to accommodate proper
plate capture.
Procedure:
1 At the bottom of the screen, tap Camera. Select the appropriate camera from the list.
2 To open camera settings, tap Settings.
3 Tap the Windowing heading. Shift the image horizontally and vertically as needed to center the
license plate capture zone.
A negative windowing value shifts the image to the left or down. A positive windowing value
shifts the image to the right or up.
NOTICE: Windowing only shifts the object in the frame and does not change the motion
trigger.
Figure 23: Shifting the Image
MN007598A01-AD
Application Configuration
25
To Next Page
Loading...
