Motorola solutions L5Q - Affixing the Front Faceplate; Figure 15: Plug in the Power Cable; Figure 16: Affixing the Front Faceplate

Figure 15: Plug in the Power Cable
3.5
Affixing the Front Faceplate
Procedure:
1 Affix the front faceplate of the Security Enclosure to the camera by sliding it over the antennas.
Figure 16: Affixing the Front Faceplate
2 Secure any excess power cable with a zip tie.
3.6
Locking the Security enclosure
Procedure:
1 Secure the Security Enclosure and the camera with the Master Cable Lock by wrapping the
cable around the pole or wooden surface.
NOTICE: Make sure to leave enough slack in the cable to enable the Security Enclosure
to articulate for aiming the camera.
MN007598A01-AD
Chapter 3 : Hardware Installation
19