Option Actions
e Wrap the excess cable length on the back of the Solar
Panel as shown in the following figure.
Figure 13: Mounting the Security Enclosure to a Pole
Mounting the Security
Enclosure to a Flat
Wooden Surface.
a Mount the Security Enclosure Mounting Bracket to the
wooden surface using the Lag Bolts and Impact Wrench
or a Socket Wrench.
b Reinsert the ball on the rear portion of the Security Enclo-
sure into the Security Enclosure Mounting Bracket and
tighten the ball lock to secure it.
c Plug in the female barrel connector of the power cable to
the rear of the Solar Panel . Wrap the excess cable length
on the back of the Solar Panel as shown in the following
figure.
Figure 14: Mounting the Security Enclosure to a Flat
Wooden Surface
3.4
Placing the Camera Into the Security Enclosure
Procedure:
1 Place the camera into the security enclosure.
2 Plug the male barrel connector on the power cable into the bottom of the camera.
NOTICE: Ensure the power cable is run into the lower left and rear corner of the security
enclosure and that the male barrel connector end fits securely into the camera.
MN007598A01-AD
Chapter 3 : Hardware Installation
18
To Next Page
Loading...
