Because the Total Event Time is only 1.8 seconds and is 0.2 seconds less than the recommended 2
seconds, the Quiet Period should be increased. Therefore, the Quiet Period should be increased by at
least 0.2 seconds. Therefore, for this example, the Quiet Period is set to 1 second because only 1
second increments are possible.
5.4
Other Settings
Table 6: Other Settings Descriptions
Settings Description
Battery Type This setting indicates to the camera what the
normal voltage level should be to accurately re-
port battery levels. Use SC10 by default. If the
camera is using the Lithium batteries only,
change this setting to Lith.
NOTICE: This setting is also used to
notify the user that the camera is en-
tering a low power state. Setting the
value to External shows the current
voltage and does not allow low volt-
age notification. Set the value to
NiMH when used with NiMH batteries.
Cellular, Day/Night Do not modify these settings.
5.5
Viewing images
Procedure:
1 Select Photos.
2 Tap More→ Filter
3 Select the appropriate camera from the camera list. Tap Apply.
4 Check the images for readable license plates. If the license plates are present, the camera is
properly configured.
MN007598A01-AD
Chapter 5 : Application Configuration
28
To Previous Page
Loading...
