8-22 Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
8.5.3.4 Servicing Reflective Label
NOTE: There is no need to remove any component in order to service the Reflective Label.
1. Scrap off the Reflective Label with the Black Stick.
2. Clean the area once the Reflective Label is completely removed to ensure it is free of
adhesive and debris.
3. Remove the label off its backer and place it in the recess.
4. Press the new replacement label for 10 seconds.
8.5.4 Servicing Volume Knob
1. Hold the radio with the top facing upward and the front of the radio facing you.
2. With the Chassis/Knob opener (P/N: PMLN7204A), grasp the Volume Knob and pull it
upward, until it is free from its shaft as shown in Figure 8-28.
3. Remove the Torque Adder from Volume Knob.
4. Align the Torque Adder to the replace Volume Knob as shown in Figure 8-29. (Marked as 1)
5. Align the D-shaped part of the shaft with the D-shaped hole on the Volume knob as shown in
Figure 8-29. (Marked as 2) Press the knob into place.
Figure 8-28. Servicing the Volume Knob
To Next Page
Loading...
