Exiting Man Down Feature
If you are not in a real Man Down situation, you should exit
the Man Down feature and prevent emergency from going
off with the following operation.
Perform one of the following actions:
• Repositioning the radio or shaking the radio
(when motion sensitivity is enabled).
• Press the preprogrammed Man Down Clear
button to exit.
• Press the Menu Select button below Clr to exit.
Re-Initiating Man Down
After exiting the Emergency Operation when the radio is
still in Man Down condition (tilted achieving threshold angle
or motionless), user must first exit Man Down condition to
then reinitiate the Man Down feature.
Return the radio to the vertical position or shake the
radio (when motion sensitivity is enabled).
Testing the Man Down Feature
Enable the Emergency feature with Silent Alarm disabled,
but not in Surveillance Mode before running this test on the
radio.
1 Turn the radio on and place in the vertical position,
for at least 5 seconds.
2 Lay the radio down in the horizontal position.
3 Wait for alert tone.
One of the following scenarios occurs:
• The radio alerts with audible tone and displays Man-
Down.
• If no tone is heard, make sure that the Man Down
feature is enabled on your radio. If Man Down feature
was not enabled, please enable it and repeat step 1 to
step 3.
• If the Man Down feature is enabled and no tone is
heard, send the radio to a qualified technician.
English
106 Send Feedback
To Next Page
Loading...
Need help?
General
