6878215A01
Motorcycle Radio Installation: Installing Antenna Base and Cables 5-17
12. Attach the 7/800, VHF or UHF antenna base per Antenna Installation Manual.
IMPORTANT: Antenna Placement and Cable Routing in the Antenna Installation
Manual is not applicable for the APX series.
13. Route the coaxial cable for the 7/800, VHF or UHF antenna(s) through the cable clamps per
Figure 5-11 for Band 1 and Figure 5-12 for Band 2.
Figure 5-11. Routing the Coaxial Cable for Band 1
Figure 5-12. Routing the Coaxial Cable for Band 2
14. After routing cable, allow enough of the cable to reach the radio’s antenna connector and cut
off any excess length of the cable.
15. Install the connector per Antenna Installation Manual.
Be sure to observe the correct routing of the antenna cable. Failure to do so can damage the
cable.
!
C a u t i o n
Cable
Clamp
Coaxial
Cable
Attach to Antenna
Connector on
Radio Band 1
Cable
Clamp
Coaxial
Cable
Attach to Antenna
Connector on
Radio Band 2
To Next Page
Loading...
