6878215A01
Standard Configurations: Radio Mounting 2-15
2.2 Radio Mounting
The mounting location must be accessible and visible. Select a location that will permit routing the
RF antenna cable as directly as possible.
NOTE: For optimum radio performance, orient the mounting trunnion as shown in Figure 2-16 or
Figure 2-17. For new or existing installations of all but 100W radios, use only the APX 7500
trunnion, kit number HLN7002_. For new or existing installations of 100W radios, use only the
APX 7500 trunnion, kit numbers HLN7003_.
Figure 2-16. Trunnion Orientation (Cannot Be Used for 100W Radios)
Figure 2-17. Trunnion Orientation for 100W Radios
DO NOT mount the radio on a plastic mounting surface without first reinforcing the
mounting surface; the weight of the radio may crack or break the mounting surface.
DO NOT mount the radio on a flat or concave surface where the radio could be
partially submersed in water. This is especially important if the cab area of the vehicle
is cleaned by spraying with water. If the radio sits in water for a length of time, moisture
may seep inside the radio and damage the electronic components.
DO NOT allow water to stand in recessed areas of vertically mounted radios. Remove
any moisture immediately to prevent it from seeping down into the radio.
Care must be taken to shield the control head (front and back) from direct exposure to
pressurized water. The pressurized water from a hose, in most cases, is more severe
than the stated test and conditions in typical environments.
!
C a u t i o n
RADIO FRONT
APPLIES TO RADIOS IN DASH AND REMOTE INSTALLATIONS
To Next Page
Loading...
