6.2.6.2
Requesting a Reprogram (Trunking Only)
This feature allows you to notify the dispatcher when you want a new dynamic regrouping assignment.
Procedure:
Perform one of the following actions:
• Press the preprogrammed Reprogram Request button to send reprogram request to the
dispatcher.
• or to RPGM then press the Menu Select button directly below RPGM to send reprogram
request to the dispatcher.
The display shows REPROGRAM RQST and PLEASE WAIT.
If you hear five beeps, the dispatcher has acknowledged the reprogram request. The display shows
ACK RECEIVED and the radio returns to the Home screen.
If the dispatcher does not acknowledge the reprogram request within six seconds, you hear a low-
pitched alert tone and the display shows NO ACKNOWLEDGE. Try again or press
to cancel and
return to the Home screen.
6.2.7
Dynamic Zone Programming
Dynamic Zone Programming (DZP) provides one or more Dynamic Zones to store frequently used
channels for conventional or trunking.
NOTICE: Your radio must be preprogrammed for you to use this feature. At least one zone in
the radio must be a non-dynamic zone.
6.2.7.1
Entering the Dynamic Zone to Select a Dynamic Channel
Procedure:
1
or to Zone then press the Menu Select button directly below Zone.
The display shows the Zone screen.
2 or to <# Dynamic Zone Channels>.
3 Perform one of the following actions:
• Press the Menu Select button below Sel to select.
• Press the Menu Select button below Exit to exit.
If you have selected one of the Dynamic Zone Channels list, the display returns to Home screen
with the selected <# Dynamic Zone Channels> shown on the screen.
If you have selected Exit without selecting any Dynamic Zone Channels list, the display returns
to Home screen without any changes.
6875947M01-HM
Advanced Features
43
To Next Page
Loading...
Need help?
General
