C24 Hardware Interface Manual
Version 0.3
CTS_N
TS24
TXD_N or
RXD_N
Module
Sleep
Idle
Disabled
Enabled
2.4.3.2 Permanent termination of Low Power Mode
The module low power mode is enabled and disabled by the ATS24 command.
To permanently terminate the low power mode, the ATS24 = 0 command must be used. Setting ATS24 =
0 disables the currently active low power mode and switches the module to Idle mode.
The module will not return to low power mode until an ATS24 > 0 commands is set again.
Motorola General Business Use
Page 15 of 36
To Next Page
Loading...
