Motorola CP160

31
English
SCAN
PRIORITIZE A CHANNEL IN A SCAN
LIST
You may want to check the activity on one or two
channels more frequently than others. You can do
this by prioritizing them:
Note: If you are receiving on a non-priority channel
and traffic becomes active on a priority
channel, your radio will automatically switch
to that priority channel and indicate the
activity with a short tone.
Set Priority Channels
Note: You cannot assign the same priority to two
different channels.
Priority Channel Scanning Sequence
None specified Ch1➠Ch2➠Ch3➠
Ch4➠…Ch1
Channel 2
(Priority 1)
Ch2➠Ch1➠Ch2➠Ch3➠
Ch2➠Ch4➠Ch2➠…Ch1
Channel 2
(Priority 1) and
Channel 8
(Priority 2)
Ch2➠Ch1➠Ch8➠Ch3➠
Ch2➠Ch4➠Ch8➠…Ch1
1 J to enter menu mode.
2
L or M until
3 J to select
4 L or M until
5 J to select
6 L or M until
7 J to select
8 L or M until
–or– until
9 J to select the desired priority level.
You see the current priority channel.
PROG LST
PROG LST
SCAN LST
SCAN LST
EDIT PRI
EDIT PRI
PRI #1
PRI #2