8
OPERATION
Turning Power On and Off
Press POWER on the front panel to turn the cable terminal on or off. When
using the remote control, be sure it is in cable mode by pressing
CABLE
before pressing
POWER.
Changing Channels
You can change channels in two ways:
• Press
CHANNEL S or T on the cable terminal front panel, or
press
CHANNEL + or - on the remote control to step through the
channel selection.
• Enter the number of the channel you wish to view using the number
keys on the remote control.
Adjusting the Volume
Press VOLUME + or – on the remote control to adjust the volume. When
you adjust the volume, the volume scale is displayed on the screen.
Press
MUTE on the remote control to turn the sound off and on again.
For best audio quality, use the remote control to set the cable terminal to
approximately ¾ of the maximum volume level, and then adjust the audio
levels on external devices such as your TV or audio/visual (A/V)
Receiver.
Interactive Program Guide
The interactive program guide (IPG) displays information about TV
programs and enables you to access features such as Parental Control
or Pay-Per-View. IPGs can vary with each cable provider. Refer to your
IPG manual for detailed instructions.
To Next Page
Loading...
Need help?
General
