Installation
High-Definition DVR DCX3510-M tInstallation Manual 13
365-095-17066-x.1
Installation
Before you move or change components on the subscriber’s entertainment system:
x Review the installation instructions.
x Determine if you are connecting the set-top to the TV by the composite (baseband)
video input or a High-Definition video input (component video, HDMI, or IEEE-1394).
x Determine if the subscriber has other equipment to be connected to the terminal
(home theater or A/V receiver, VCR, etc.).
x Verify that you have the necessary cables and other required items.
x If the terminal was previously used, clear its hard drive before installing it at a new
subscriber location.
Cold Reset Procedure
This section describes the Cold Reset procedure for Motorola’s DCX3510-M set-top.
The cold reset is generally used by operational and field personnel to accomplish the
following:
x Restore the set-top to a known state.
x Clear channel maps and application settings.
x Remove application and software objects above the platform code.
x Clear the Out of Band (OOB) Last Known Carrier (LKC) and force the units to hunt for
a new OOB control channel.
Remote Control Cold Reset
1. Remove the set-top from its packaging.
2. Apply AC power to the set-top.
3. Point the remote control at the set-top and press the SELECT key.
The POWER LED on the front panel begins to flash slowly.
4. Release the SELECT key.
5.
Within 2 seconds, press the 3 key on the remote control.
The POWER LED flashes quickly.
6. Within 2 seconds, press the 2 key on the remote control.
The POWER LED will flash slowly.
7.
Within 2 seconds, press the 8 key on the remote control.
The POWER and MESSAGE LEDs flash two times, and the set-top performs a cold
reset operation.
3
To Next Page
Loading...
Need help?
General
