Motorola DCX3520e-M - Table 25: Interactive Status Diagnostic Field Descriptions

Diagnostics 
High-Definition DVR DCX3510-M tInstallation Manual 88
365-095-17066-x.1
Table 25: Interactive Status Diagnostic Field Descriptions
Field Description
IP Address
The IP address in dotted-decimal format xxx.xxx.xxx.xxx assigned by the NC 1500
to the DCX3510-M. 0.0.0.0 is displayed if the IP address is not configured or
unknown.
UPM
The upstream modem address value is the same as the terminal ID assigned by the
DAC 6000. It is a unique, system-generated, eight-digit integer between 1 and
16777215. 00000000 is displayed when the UPM is not configured or if it is
unknown.
Upstream ID
A four-digit decimal value from 0000 to 9999 assigned by the DAC 6000 to the
DCX3510-M. 0000 is displayed if the Upstream ID is not configured or if it is
unknown.
Downstream ID
A four-digit decimal value from 0000 to 9999 assigned by the DAC 6000 to the
DCX3510-M. 0000 is displayed if the Downstream ID is not configured or if it is
unknown.
State
The interactive status of the DCX3510-M:
Front Panel OSD Description
U UNCONFIG The DCX3510-M is not configured for
the interactive system, and the
platform should run as pre-interactive.
C MAC_CONNECT The DCX3510-M is waiting to establish
a connection to the MAC PID Stream.
Front Panel OSD Description
I dc INIT_WAIT_DC_OR_C The DCX3510-M is in the interactive
initialization state and waiting for the
default configuration or the contention
channel list messages.
I L WAIT_LM_ACK The DCX3510-M is in the interactive
initialization state and waiting for Link
Management Response ACK for Local
Address Message.
I SO
WAIT_SO_ACK
The DCX3510-M is in the interactive
initialization state and waiting for a
Sign On acknowledgement.
I LA WAIT_LA_OR_SO The DCX3510-M is in the interactive
initialization state and waiting for
Logical Address or Sign On with
verification Frequency message.