43
English
SCAN
SYSTEM SCAN G
System Scan scans trunked talkgroups and
conventional channels between LTR and
conventional zones, as programmed by your
dealer. Up to 16 different talkgroups or
conventional channels can be programmed
into each Scan list. You can edit these lists
through your radio’s menu (see page 44).
When System Scan is enabled:
•The G symbol appears on the LCD
screen.
• The LED indicator blinks green during Sys-
tem Scan operation; it stops blinking when
the radio switches to an active talkgroup or
channel.
Note: If you enter menu mode while the radio is
scanning, scanning stops. It resumes when
you exit menu mode.
To start or stop a System Scan operation:
Press the preprogrammed System Scan
button (see page 21) to start or stop scanning,
–or–
Do the following:
DELETING A NUISANCE CHANNEL/
TALKGROUP
(SYSTEM SCAN OPERATION ONLY)
If a talkgroup or channel continually generates
unwanted calls (a “nuisance” channel), use the
preprogrammed System Scan button to
temporarily delete the talkgroup or channel
from the Scan list.
1 ) to enter menu mode.
2 + or ? until
3 ) to select
You see the current scan status.
4 + or ? until
–or–
5 ) to confirm your selection.
System Scan
System Scan
Sys Scan On?
Sys Scan Off?
07_Scan.fm Page 43 Thursday, September 5, 2002 5:02 PM
To Next Page
Loading...
Need help?
General
