51
English
PHONE
D appears on the LCD screen when you are
in Phone Mode.
5 (For conventional operation with auto access
only). You hear a series of tones, indicating
that an access code is being sent automati-
cally, and see your access code:
–or–
Enter your access code using the keypad.
6 When you hear a dial tone:
Enter the phone num-
ber using the keypad.
–or–
+ or
? to select
a number from the
phone list.
–or– (see step 7)
XXX-XXX-XXXX
XXX-XXX-XXXX
7 a Press and release the preprogrammed
Speed Dial button (see step 6) to use the
Speed Dial feature.
b Press the key (1 to 9) corresponding to the
number you want to call, or press 0 if you
want to call the last number dialed.
Note: To redial the last number dialed (if
not using Speed Dial), press and
release the PTT button immediately
after the access code is sent. The
radio sends the last number dialed.
–or–
If you entered your access code
using the keypad, press the ? key
once to access the last number
dialed; then press and release the
PTT button.
8 Press and release the PTT button, if required
for your radio.
9 Hold the radio in a vertical position with the
microphone 1 to 2 inches (2.5 to 5 cm) away
from your mouth. Press the PTT button to talk;
release it to listen.
08_Phone.fm Page 51 Tuesday, September 24, 2002 10:22 AM
To Next Page
Loading...
