21
Trunked Telephone Operation
(cont.)
Calling a Stored Number using Direct Access
1. To make a phone call, press the (Phone)
button.
2. Access will be displayed momentarily and then the
last dialed phone number.
Notes:
• If you are out of the trunked system range or the
phone interconnect is out of service, “no PHonE”is
displayed for six seconds after trying to access the
system, and a continuous low-pitched tone is
emitted.
• If the trunked phone interconnect is in use, a busy
tone sounds and “PH buSY” is displayed. If you
hang up, you will lose your place in the queue.
• This is a timed message. If you cannot access the
telephone system (no dial tone heard), you need to
press the to hang up, and start again from
step 1 of this procedure.
Note:
• The display is able to accommodate eight digits. If
the last dialed number is more than eight digits
then the first eight and the digits after the first
eight digits are displayed alternately.
To Next Page
Loading...
