EasyManua.ls Logo

Motorola IMPRES - Important Safety Instructions; Battery and Accessory Safety; Charger and Cord Handling; Damaged Charger Operation

Motorola IMPRES
256 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
English
OPERATIONAL SAFETY GUIDELINES
Turn the radio off when charging the battery.
This equipment is not suitable for outdoor use. Use only in dry
locations/conditions.
Connect equipment only to an appropriately fused and wired supply
of the correct voltage (as specified on the product).
Disconnect from line voltage by removing the mains plug from the outlet.
The socket outlet to which this equipment is connected should be
close and easily accessible.
For equipment using fuses, replacements must comply with the type
and rating specified in the equipment instructions.
Maximum ambient temperature around the charger must not exceed
40°C (104°F).
Make sure the cord is located where it will not be stepped on, tripped
over, or subjected to water, damage, or stress.
This unit utilizes the same wall mount unit as the NTN4796 Multi Unit
Charger. The wall mount part number is NLN7967.
For fuse replacement, use only fuses of the same type and rating
listed on the charger label. The following parts can be ordered from
your local Parts / Aftermarket facility:
Fuse 6571489S01
Holder 0987626G01
Cover 0987739G01
37D22-B_Impres_MUC_EN.fm Page 3 Wednesday, July 12, 2006 2:02 PM

Table of Contents

Other manuals for Motorola IMPRES

Related product manuals