18
English
English
Charger Calibrating an IMPRES Battery
LED Steady YELLOW, RED,
Flashing YELLOW or GREEN
Line 1 Calibrating
Line 2 Battery
LED Steady GREEN
Line 1 Battery
Line 2 Calibrated
* All IMPRES batteries should be calibrated before ini-
tial use. Charger will automatically initiate calibration
for all new batteries.
Battery Capacity Data is Displayed as % in
mAH, and Voltage
LED Defined by Charge State
Line 1 ----% RATED CAP.
Line 2 ----mAH --.-V
Note: Not shown for uncalibrated batteries.
Note: Display will show slightly lower capacity after
reaching charge completion if battery inserted in
another pocket due to stand loss calculations, but the
charger will correct this deviation when the battery
reaches full charge in the new pocket, typically in a
few minutes.
CDM_Install - B.fm Page 18 Monday, February 10, 2003 2:51 PM
To Next Page
Loading...
