STANDARD DEFAULT PARAMETERS A - 3
Timeout Between Decodes, Same Symbol 0.5 Sec
5-19
Timeout Between Decodes, Different Symbols 0.2 Sec
5-19
Decoding Illumination Enable
5-20
Miscellaneous Options
Transmit Code ID Character None
5-21
Prefix Value 7013 <CR><LF>
5-22
Suffix 1 Value
Suffix 2 Value
7013 <CR><LF>
5-22
Scan Data Transmission Format Data as is
5-23
FN1 Substitution Values Set
5-24
Transmit “No Read” Message Disable
5-25
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type IBM PC/AT& IBM PC
Compatibles
1
6-4
Country Types (Country Codes) North American
6-5
Ignore Unknown Characters Send
6-7
Keystroke Delay No Delay
6-7
Intra-Keystroke Delay Disable
6-8
Alternate Numeric Keypad Emulation Disable
6-8
Caps Lock On Disable
6-9
Convert Wedge Data No Convert
6-10
Caps Lock Override Disable
6-9
Function Key Mapping Disable
6-10
FN1 Substitution Disable
6-10
Send and Make Break Send
6-11
RS-232 Host Parameters
RS-232 Host Types Standard
7-6
Baud Rate 9600
7-8
Parity Type None
7-9
Stop Bit Select 1 Stop Bit
7-9
Table A-1
Standard Default Parameters Table (Continued)
Parameter Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
