User Manual
68
Se
lect Enable QoS to enable QoS and configure the default DSCP mark.
In thi
s page, enable the QoS function and select the default DSCP mark.
After finishing setting, click Apply/Save to save and apply the settings.
Note:
If the En
able Qos checkbox is not selected, all QoS will be disabled for all
interfaces. The default DSCP mark is used to mark all egress packets that do
not match any classification rules.
Queue Configuration
C
hoose Advanced Setup > Quality of Service > QoS Queue, and the following
page appears.
To Next Page
Loading...
