Installation
73
Installation Procedures
Follow these procedures to install the radio in the desired location. If the
accessory mounting tray is not used, ignore the steps pertaining to it.
Mobile Mounting Kit
Step 1.
Mount the accessory mounting tray in the desired location. Use
the tray as a template if holes must be drilled.
Figure 7: Accessory Mounting Tray
Step 2.
Use the four supplied screws to fasten the mounting tray
bracket to the bottom of the radio housing.
Step 3.
Drill an additional hole for the ground bolt.
DC Power Connection
This paragraph describes connections to a 12-V negative-ground
vehicular battery.
Figure 8: DC Power Connection
To Next Page
Loading...
