MICOM-2E-ALE Owner’s Manual
76
Microphone Clip
The microphone cable enables placing the microphone clip in any
convenient location up to five feet from the radio. To install the clip, use
it as a template to drill two holes to receive self-threading sheet-metal
screws. Mount the clip using the supplied screws.
Figure 10: Microphone Clip
Final Connections
Step 1.
Ensure that the radio is off. Then connect the power cable to
DC connector J4 and connect the antenna RF cable to antenna
connector J2.
If an antenna tuner is used, connect the antenna to the tuner,
connect the tuner RF cable to connector J3, located on the
radio rear panel.
Step 2.
If the mounting tray is used, slide the radio into the tray and
fasten the tray bracket with the supplied screw.
To Next Page
Loading...
