Operating Instructions
21
Working in BITE Mode
BITE mode is a testing mode that you use for maintaining MICOM-2E.
To enter BITE mode:
1. Press to display the Menu screen.
2. Press [BIT].
Once you are in BITE mode, the mode options appear in the LCD
display:
•
[FULL] runs a full test of the hardware device.
•
[CHAN] tests the device on the current channel.
•
[L.RF] low RF; tests the reception path only.
See the section entitled “Built-In-Test Equipment (BITE)” on page 81 for
more information regarding the use of this mode.
To Next Page
Loading...
