RETROFITTING the GPS and UCM BOARD C - 3
Figure C-3 Location of UCM connector J0450 on the main board
UCM Software activation
After installing the UCM hardware, a software upgrade for the MTM800 ENH will be necessary.
Please refer to the CPS documentation in the Product Information Manual (P/N: 6866537D87) for
more details.
Before use, provision the UCM with E2E Keys and Associations according to your E2E Deployment
Plan. This will require a Key Variable Loader (KVL), and may also require configuration changes to
your system's Key Management Facility (KMF).
Refer to the Dimetra End-to-End Encryption KVL 3000 Plus Key Variable Loader User Guide
(P/N: 6802800U14) for more details. For questions refer to your local Customer Support Centre (see
Appendix B - Service Information).
short bending
to main board
UCM flex
UCM connector
J0450
UCM
board
*
*
*
contacts on back sid
6866539D31.book Page 3 Tuesday, March 20, 2007 6:32 PM
To Next Page
Loading...
