6 - 6 TEST SETUP & TESTING
o. Press the "Return" soft key.
p. Verify that channel block 2 to 8 are excluded.
q. Press the "Return" soft key.
9. Press the "Control Channel" soft key and enter "2440" for 450-470MHz using the
data keys followed by the "Control Channel" soft key.
10. Press the "Traffic Channel" soft key and enter "2440" for 450-470MHz using the data
keys. Press the "Traffic Channel" soft key again and check that the marker goes to
Timeslot. Press data key "3" followed by the "Traffic Channel" soft key, to change to
Timeslot "3".
11. Press the “Country Code” soft key.
Enter “262” and press the “Country Code” soft key.
12. Press the “Network Code” soft key.
Thereafter, enter “75” and press the “Network Code” soft key.
13. Press the “Base Color” soft key.
Thereafter, enter “1” and press the “Base Color” soft key.
14. Press the “Location Area” soft key.
Thereafter, enter “224” and press the “Location Area” soft key.
15. Press the “Min Rx Level” soft key.
Thereafter, enter “-110dBm” and press the “Min Rx Level” soft key.
16. Press the “Max Tx Level” soft key.
Thereafter, enter “35dBm (3.2W)” and press the “Max Tx Level” soft key.
17. Press the “Access Parameter” soft key.
Thereafter, enter “-33dBm” and press the “Access Parameter” soft key.
18. Press the “Test Mode” soft key. Press the “Enable” soft key.
19. Press the “Base Service” soft key.
20. Press the “Suport” soft key if it is displayed
or verify that the following values are displayed:
POWER ON REGISTRATION: REQUIRED
POWER OFF DE-REGISTRATION: REQUIRED
PRIORITY CELL: YES
MINIMUM MODE SERVICE: NEVER USED
MIGRATION: SUPPORTED
SYSTEM WIDE SERVICE: NORMAL MODE
TETRA VOICE SERVICE: SUPPORTED
CIRCUIT MODE DATA SERVICE: SUPPORTED
(RESERVED): NOT AVAILABLE
SNDCP SERVICE: NOT AVAILABLE
AIR INTERFACE ENCRYPTION: NOT AVAILABLE
ADVANCED LINK: NOT SUPPORTED
Note: The displayed values are factory defaults and should not be changed.
6866539D31.book Page 6 Tuesday, March 20, 2007 6:32 PM
To Next Page
Loading...
