Parameter Value
RF Channel Bandwidth kHz 25
Transmitter RF Output Power W 1 (Class 4) and 1.8 (Class 3L 1.8 W)
RF Power Control 3 Steps of 5 dB
RF Power Level Accuracy +/-dB 2
Adaptive Power Control Per EN 300 392-2
Receiver Class A and B
Receiver Static Sensitivity dBm -112 minimum (-115 typical)
Receiver Dynamic Sensitivity dBm -103 minimum (-107 typical)
Table 3: GPS Specification
Parameter Value
Simultaneous Satellites 12
GPS Antenna
Helical - integrated into TETRA Antenna
Sensitivity -152 dBm / -182 dBW
Accuracy (Measured at -137 dBm)
5 meters - 50% probable
10 meters - 95% probable
Protocols ETSI LIP & Motorola LRRP
Note: This specification may be subject to change without further notice. All product features are subject to
infrastructure support. Selected features are subject to optional software upgrade.
Ordering Options for Radios and Features
TETRA terminals are only available to accredited channel partners who are advised of the discount structure applied
to these products.
Software options can be ordered and enabled in three ways:
• You can have them enabled at the Distribution Centre (DC).
• If you have iTM, you can enable them with a license.
• You can order by using a dongle.
Dongle Enablement – Software Enablement Kits
Each software enablement kit ordered provides one dongle for the customer with a specific number of counters set
according to the number of software options ordered. This kit number is applicable to both new orders or existing
fielded terminals which require software enablement.
The features are enabled at the same time the customer programs the radio. The enablement for all the selected
features is performed in one operation.
Product Overview | 17
| | Send Feedback
To Next Page
Loading...
