41
Packet Data
The Packet Data (PD) Service allows you to transfer data in a
TETRA system using the Internet Protocol (IP). Check with
your Service Provider for the availability of this feature.
If set up by your Service Provider it is possible to accelerate
the transmission by using the Multi-Slot Packet Data (MSPD)
Service (refer to “Packet Data” on page 163).
Reseting the Terminal to Default Settings
This feature can be triggered only when you are in the idle
display of TMO, DMO, TXI, Repeater or Covert mode.
Otherwise, Reset only available in idle display is
displayed.
Check with your Service Provider which One-Touch Button is
assigned for that feature. For more information regarding
OTB, go to “Programmable Keys (0-9, * and #)” on page 25.
For transferring data from a standard computer over the air
connect the computer via the Active Data Cable FKN4897 with
your MTP850. Your Service Provider has to setup additional
applications on your computer.
To Next Page
Loading...
