Motorola MTP850 - Selecting DMO Group Call via Gateway

57
DMO Group Call
Selecting DMO Group Call via Gateway
While in DMO, proceed as follows to choose a gateway to set
up a call via Gateway for the selected talkgroup:
1. Press Optns, scroll to Config and press Select.
2. Scroll to Gateway and press Select.
3. The display shows the last gateway selection method. Use
the navigation key to scroll to your selection and press Ok:
Automatic
– the MTP850 will use the first
available gateway for that talkgroup. The
Gateway icon will flash upon selecting that
option.
Specific
– the MTP850 will use only the
gateway with the specified Gateway
address for that talkgroup.
Upon selecting “Specific”, you will see one of the following
displays:
• The selected gateway address (e.g.:
1022), pre-programmed by your Service
Provider or previously entered by yourself
via the keypad. Press Edit and then Ok to
use the current address, or enter a new
address via the keypad, and press Ok.
The Gateway icon will flash upon selecting
the gateway.
• “None”, indicating that no gateway was
selected for that talkgroup. Press Edit and
enter an address via the keypad, Press
Ok. The Gateway icon will flash upon
selecting the gateway.
When the MTP850 detects the suitable
gateway, the Gateway icon will turn solid.
GW Options:
Automatic
Specific
Select Back
Selected
Gateway:
1022
Edit Back
Selected
Gateway:
None
Edit Back
DMO Folder 1
Police
Hello
Optns Contcs