2 Select Networks → TG Net Sel → Any TG Net.
Your radio selects and registers to the network automatically from the predefined list.
4.19
Location
NOTICE: This feature is a selling feature.
This sub-menu allows you to enable the GNSS, change GNSS accuracy, and view your position and
testpage.
See Global Navigation Satellite System (GNSS) Location Service on page 147.
4.19.1
Enabling GNSS
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Interface.
3 Select On.
NOTICE: Your service provider can enable this feature.
4.19.2
Viewing Your Position
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Position.
3 Scroll to view the results about the last time your location was calculated.
NOTICE: To refresh your position:
• Select Position – the radio refreshes its position automatically
• Press Refresh
4.19.3
Viewing Testpage
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Testpage.
3 Select one of the following options:
• Position – displays detailed information on radio’s current position: time, N (latitude), E
(longitude), H (height), Sats Used (a number of tracked satellites), B (bearing), HS
(horizontal speed), LC (level of confidence).
• Power – displays detailed information on a particular satellite: PRN code, Status, Mode, C/N
(carrier-to-noise ratio).
MN002041A01-AH
Chapter 4: Main Menu
136
To Next Page
Loading...
