• Press Select.
• Press the PTT button.
• Press the Send key.
4.3.9.3
Targeted Status Messages
The Targeted Status Messages feature enables sending status messages to addresses that can be
selected by the user.
By default, targeted status messages can be sent to private or talkgroup addresses.
Your service provider can restrict valid addresses to numbers stored in Contacts.
NOTICE: This feature is not supported on Dimetra networks.
4.3.9.3.1
Sending Targeted Status Messages
Procedure:
1 From the home screen, press the Menu key.
2 Select Messages → Send Status.
3 Do one of the following:
• Highlight the required status message and press the Send key.
• If the status list is empty, enter a 5-digit status message number and press Send.
4 Highlight the required status message and press the Send key.
5 Do one of the following:
• Enter the number or press abc to select the name from your contact list. Press Send.
• Select the required talkgroup from the TalkGroup List.
The display shows one of the following delivery reports:
• Status Sent
• Status Failed
4.3.10
Sending an RMS Status
Prerequisites: This feature is only available when enabled by your service provider. See Radio
Messaging System (RMS) on page 152 for details.
Procedure:
1 Do one of the following:
If… Then…
If the radio is in the
RMS mode,
go to step 2.
If the radio is not in
the RMS mode,
a Do one of the following:
MN002041A01-AH
Chapter 4: Main Menu
85
To Next Page
Loading...
