Motorola MTP8550Ex - Changing GNSS Accuracy; Backlog; Enabling or Disabling Backlog; Viewing Backlog Reports

• Version – displays detailed information on software version: SW (software version), HW
(hardware version), ASIC (application-specific integrated circuit), RC (release code).
4.19.4
Changing GNSS Accuracy
Procedure:
1 From the home screen, press the Menu key.
2 Select More . . . → Location → Accuracy.
3 Select one of the following options:
• Medium (default) – Power consumption optimization is combined with less position accuracy.
• High – Better position accuracy is combined with less power consumption optimization.
NOTICE: If connected to an external charging device, the radio automatically enters the
High mode.
4.19.5
Backlog
This sub-menu allows you to enable/disable, view, and delete backlog reports.
NOTICE: The location report backlog is only available when Local Information Protocol (LIP) is
enabled.
4.19.5.1
Enabling or Disabling Backlog
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Enablement.
3 Select one of the following options:
• On – Activates location report backlog recording.
• Off – Deactivates location report backlog recording.
4.19.5.2
Viewing Backlog Reports
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Reports.
The radio displays the number of backlog reports stored.
4.19.5.3
Deleting All Backlog Reports
Procedure:
1 From the home screen, press the Menu key.
MN002041A01-AH
Chapter 4: Main Menu
137