viii
CHAPTER 2 HARDWARE PREPARATION AND INSTALLATION
Introduction.................................................................................................................2-1
Unpacking Instructions..............................................................................................2-1
Hardware Preparation ...............................................................................................2-1
SIM Selection........................................................................................................2-2
Removal of Existing SIM.............................................................................2-4
Installation of New SIM ..............................................................................2-5
System Controller Select Header (J1)................................................................2-5
Synchronous Clock Select Header (J11) for Serial Port 1/Console ..............2-6
Clock Select Header (J12) for Serial Port 2.......................................................2-6
SRAM Battery Backup Source Select Header (J20).........................................2-7
EPROM Size Select Header (J21).......................................................................2-7
General-Purpose Readable Jumpers Header (J22)..........................................2-8
Installation Instructions.............................................................................................2-9
IP Installation on the MVME162 .......................................................................2-9
MVME162 Module Installation .......................................................................2-10
System Considerations .....................................................................................2-12
CHAPTER 3 OPERATING INSTRUCTIONS
Introduction.................................................................................................................3-1
Switches and LEDs.....................................................................................................3-1
ABORT Switch (S1)..............................................................................................3-1
RESET Switch (S2)...............................................................................................3-1
Front Panel Indicators (DS1 - DS4) ...................................................................3-2
Memory Maps.............................................................................................................3-3
Local Bus Memory Map .....................................................................................3-3
Normal Address Range...............................................................................3-3
Detailed I/O Memory Maps..............................................................................3-7
IPIC Overall Memory Map.......................................................................3-17
BBRAM, TOD Clock Memory Map.........................................................3-21
Interrupt Acknowledge Map....................................................................3-24
VMEbus Memory Map.....................................................................................3-24
VMEbus Accesses to the Local Bus..........................................................3-24
VMEbus Short I/O Memory Map............................................................3-24
Software Initialization..............................................................................................3-24
Multi-MPU Programming Considerations....................................................3-24
Local Reset Operation.......................................................................................3-25
To Next Page
Loading...
