Installation 15
The Free-standing Pedestal Mount
The Free-standing Pedestal Mount affixes to the vehicle’s floor or transmission hump using
self tapping screws or bolts. It allows the display mount to be readjusted to either the driver
or passenger side for most comfortable viewing angle. A single adjustment knob enables
adjustment of both upper and lower ball joints simultaneously.
This section describes the tools and equipment, planning requirements, and product
i
n
spections necessary for a smooth installation of the 8.4" Display.
Proper planning will help to ensure that the installation is completed without difficulty and
that
no damage occurs to the units or the vehicle.
.
To install the Free-standing Pedestal Mount, perform the following steps (see Figure 12):
Step 1. Select the location to achieve optimal functionality and use of the 8.4" Display.
The 8.4" Display is a reliable product when installed correctly.
However, performance can be seriously impaired if it is not installed
correctly. Thoughtful planning can make the difference.
Please note that installing any part of the 8.4" display must be according
to the instructions provided in this manual.
Figure 11
MW810 8.4” Display - Free-standing Pedestal Mount
Adjustment Knob
Four M4, 10 Screws
To Next Page
Loading...
