Motorola Razr V3x Personalization Guide (MoGu V3xPG) V2.5
(Volume 1– Primary Mods)
V3X Personalization Guide-V2-5-eb-v1-061205.doc 8 of 227
ebentley
You're b l you need to do now is expand the categories that are related to your V3x and right click and
select "Unin
would be M ame Motorola (Make sure you don't actually have a Motorola USB Modem that
you use
asically done. Al
stall." You'll need to figure out which drivers you personally installed your Phone under. The best guesses
odems with anything of the n
as a Modem. Then follow the “Getting Connected” tutorial of my site.
atu and you should be able to successfully connect your handset to
d Luck in your modding efforts.
pletely to the right for "Unlimited"
"Select a phone's drives partitions" box, make sure the a/ radio button is selected
OK
right drive selection window (assuming the right window shows the phone) click the down arrow and
e read. If they are not, click the "Re-read" button
roperly. Good work!
P= How To Get Into Boot Loader?
= With the phone turned off but connected to the computer, press * + # + power key (that’s right—this will take 3 fingers)
Congr lations! Your P2k drivers are now installed
begin your modding operations. Goo
Now, to test the connection:
• Make sure your phone is connected to the computer vie data cable
• Open P2K Commander
• Click the "Options" Menu item
• Make sure the slider (Number of files to load) is positioned com
• In the
• Click
• In the
select P2K Mobile Phones
• If connected properly, that selection will now be visible in the window and all of the the phone's directories
should b
Note: You may have to unplug-then replug your phone, then make the P2K Mobile Phones selection to cause P2K
ommander to read the phone pC
1.1.5 Starting the Phone in Boot loader Modes
F
and hold until the screen flashes white, then release the keys and you will see the following message:
Boot Loader
0.6.8.2 (Whatever your Bootloader version is)
SW Version: R252211LD_U_85.9A.70R (Whatever your SW version is)
OK to Program
Transfer Mode:
USB
No
ha
te: er mod be in USB tran
nds
You ca -2 by unplugging the handset; turning off the phone, and
ssi
Note: To exit Boot Loader Mode: Simply pres art the phone as normal
To flash your phone in Boot Load
et otherwise.
n also start Boot Loader in Serial RS
e, you need to sfer mode. The tools won’t recognize the
32 Transfer mode
s the “off” key. Re-st
pre ng the * + # + power key
Now let’s get started on some V3x Personalization
The ta s what I normally do to my phone I like them. You can modify the tasks in ble below illustrate s to get them the way
the table to fit your need
s.
To Next Page
Loading...
Need help?
General
