Motorola Razr V3x Personalization Guide (MoGu V3xPG) V2.5
(Volume 1– Primary Mods)
V3X Personalization Guide-V2-5-eb-v1-061205.doc 38 of 227
ebentley
•
s
Now the se ion is to get the backlight function for the external LCD operating--especially when the flip
is open ve
a total solu
www.7900n
Part 2. (this can't be done now) How to get the backlight functioning when the flip is on (so you can see the
cu tomized gif)?
cond part of the solut
. As has been stated in numerous threads, this is being looked at right now. Until this is figured out--we don't ha
tion. BTW: Steve8411 already had these instructions posted on his website:
ovadrive.com/v3/v3x.htm which is probably where I got them from initially.
Thanx Steve and everyone else who provided feedback regarding this mod. -eb-.
1.8 ol
1.8
The V3x norma is battery is installed, the back cover is rather loose and often
squeaks or the ere is an air-gap between the top of the
battery and the t attery loses contact with the batter connections on the phone.
You can either nd battery cover to get rid of the gap,
or you can use following benefits:
a.
b. ttery and battery cover and it
e ttery
n
Ba
Motor a Batteries (BC-60 and BC-70) and Battery Covers
.1 Using the Motorola BC-70 Battery and fitting the V3x Battery Cover
lly ships with the Motorola BC-60. When th
phone will intermittently turn off when you close the flip because th
ba tery cover and when you close it the b
put some paper or anything non-conductive in between the battery a
the Motorola BC-70 battery and it will provide the
It provides a longer charge
Since the BC-70 is thicker than the BC-60, it fills the air-gap between the ba
cr ates a tighter fit so the phone will no longer squeak and the battery won’t lose contact with the ba
co nections when closing the flip.
ttery Cover Installation
: It will take some gentle, but persistent pressure to get the battery cover in p
ed but it will fit. I find that sliding the battery cover into position with it almost level with the top
lace with the
BC-70 install battery,
an
of the
d using gentle
pressure, the cover closes tightly, but properly. Once in place, you’ll have to be persistent to get th
ttery cover off again (it’ll take 2 hands) but after you do it a couple of times, it will become easier. BE CAREFUL SO
U DON’T BREAK ANYTHING! I’m not responsible if you do.
.1.1
e
ba
YO
1.8
Want a BC-70 High Capacity Battery and live in the USA? [Steve8411]
Ho
If y e SLVR phone>Accessories.
The BC 70 b
aw
1.8
Ra
da mes from Germany and I
paid incl. P&P just under 20 Euros sending it to the UK, but they ship worldwide and accept PayPal. Here is the eBay
link. Money well spent!!!
htt
V3
Re
Hi
Th
small. A full recharge takes more than 2 hours in the phone, and the battery temperature is quite high when it is finished.
w to play the game! USA does not have a V3x ...but we do have a SLVR and the batteries are the same!
ou are in the USA and want the BC 70 battery. Go to hellomoto.com and navigate to th
attery will be listed there and you can order it for $40.00. Take 2 mins and register for one of their give-
ays/promotions and wait 10 mins ...you'll get an email coupon for 10% off .....
.2 A Potential High Capacity Battery Replacement for the Motorola BC-60 (Rasputin007)
sputin007 found this battery on eBay and here’s what he says: I have got a 1700 mAh, 3.7V battery for the V3x a few
ys ago, which I bought on Ebay. After 48 hours I still have all 3 battery bars. The battery co
p://cgi.ebay.co.uk/Power-Akku-1700mAh-Motorola-L6-SLVR-L7-L8-V3x-V3i-
_W0QQitemZ9120751914QQcategoryZ32964QQtcZphotoQQcmdZViewItem
sponse from nadorsz:
there. I bought the "1700mAh battery" more than two weeks ago. It has at least 1.5x capacity than the original one.
ink it is physically impossible to charge it to the maximum capacity of 1700mAh because the charge currency is quite
To Next Page
Loading...
Need help?
General
