Motorola RAZR MAXX

Motorola Razr V3x Personalization Guide (MoGu V3xPG) V2.5
(Volume 1– Primary Mods)
V3X Personalization Guide-V2-5-eb-v1-061205.doc 37 of 227
ebentley
note that on the right hand side, it reads "[]/[]a[]/[]c[]l[].[]g[]i[]f[][]". Make sure that both 0061 and 0062 seems are
pointing towards the correct file in the correct folder (so both of them should be like the picture above).
• Load the SEEM you downloaded into LeaderGL or p2kman, then save it to the phone as SEEMs 0061_0001 and
0062_0001 (just change the name from 0061 to 0062 and upload the same file). Just rename the file. YES, SEEM
0062 and 0061 are identical. 0062_0001 is a backup SEEM.
• Now load SEEM 004a_0001 and find offset 27. Set the value to 00 (i.e. uncheck all the bits because you should
• Save it back to the phone.
• Open and close your flip. When you close it, you will see that your customized graphic will display but will, almost
e flip is open—at least not yet;>)
I’ve p that this part of a total solution does work for the V3x.
You CAN repl u close your flip--then it is replaced by your set
wa
st
2
nd
part NOT
do
Part 1. (this can be done now) How do I change the external LCD gif and get it to display (even if only
find that bit 1 is checked when you first download it).
• Now restart the phone
immediately, be replaced by your set wallpaper. It will not display while th
confirmed (I just did it on my black V3x) with Steve8411’s hel
ace the cl.gif but it is only visible momentarily when yo
llpaper. Actually, this has always been a two-part question with the 1
part being doable now and the
able right now:
•
momentarily when I close the flip? And,