Section 2H: Using Your Phone’s Voice Services 105
Voice Services
Using Send Text <Name or #>
Use Voice Recognition to open Text Messaging to the Create
Message screen, with the recipient already addressed.
To launch Text Messaging and address a message:
1. Press Smart Key. (Your phone displays the Say a command
screen.)
2. Say Send Text followed by the name (if the recipient is
saved to Contacts) or the number.
3. Use your keypad to enter the message and then press
Send (left softkey). (See “Using SMS Text Messaging” on
page 167.)
If you do not specify the type of number and there are
multiple numbers for the name, Voice Recognition chooses the
mobile number by default.
If you say Send Text without specifying a recipient or a
number, your phone prompts you for this information.
Note:
You cannot send SMS Voice messages to Distribution Lists
using Voice Recognition.
Note:
You cannot send SMS Text messages to Distribution Lists
using Voice Recognition.
To Next Page
Loading...
Need help?
General
