Section 2A: Phone Basics 37
Phone Basics
Using Speed Dialing
You can store up to 900 numbers in your phone’s speed dial
memory. With this feature, you can speed dial entries using
one key press for locations 2-9, two key presses for locations
10-99, three key presses for locations 100-999, and four key
presses for location 1000.
For Speed Dial locations 2-9 (One-Touch Dialing):
䊳 Press and hold the appropriate key for approximately
two seconds. The display screen confirms that the
number has been dialed when it shows “Connecting...”.
For Speed Dial locations 10-99 (Two-Touch Dialing):
1. Press the first digit.
2. Press and hold the second digit for approximately two
seconds. The display screen confirms that the number
has been dialed when it shows “Connecting...”.
For Speed Dial locations 100-999 (Three-Touch Dialing):
1. Press the first two digits.
2. Press and hold the third digit for approximately two
seconds. The display screen confirms that the number
has been dialed when it shows “Connecting...”.
Note:
You must enable speed dialing before you can use it. See
“Calling Options” on page 59 for instructions.
Speed dialing is not available when you are roaming; when
you are roaming off the Sprint National Network, you must
always dial using 11 digits (1 + area code + number).
Note:
For Speed Dial location 1000, press 100 and then press and
hold the final 0. Location 1000 cannot be used if Abbreviated
Dialing is active (see page 36).
To Next Page
Loading...
Need help?
General
