PROGRAMMING
FEATURES
English
52
• Wait for 3 seconds before releasing the
buttons until a distinctive audible tone is
heard.
3.
Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Press and release SB1.
4.
After cloning is completed, the Source radio will
announce either ‘pass’ (cloning was successful)
or ‘fail’ (cloning process has failed). If the Source
radio is a display model, it will either show ‘Pass’
or ‘Fail’ on the display (a tone will be heard within
5 seconds).
5.
Once you have completed the cloning process,
turn the radios OFF and ON to exit the ‘cloning’
mode.
•
If cloning fails please refer to “What To Do if
Cloning Fails” on page 52.
Further details on how to clone radios are
explained in the Instructions Sheet provided
with the MUC.
When ordering the MUC, please refer to
P/N PMLN6384A.
Notes:
•
Paired Target radios and Source radios must be
of the same band type in order for the cloning to
run successfully.
•
(*) MUC pockets numbers should be read from
left to right with the Motorola logo facing front.
To Next Page
Loading...
Need help?
General
