2 - 6 SE4750 Integration Guide
Mounting
There are several mounting holes (M1.6x0.35) and locator holes on the bottom of the chassis (see Figure 2-4). The
SE4750 can be mounted in any orientation without degradation in performance.
When installing the mounting screws, ensure they do not protrude past the mounting hole threads in the chassis;
use 2.1 mm maximum mounting screw thread engagement. Recommended mounting screw torque is 1.25 ±0.25
in-lb.
Figure 2-4
SE4750-SR LSR AIM Mounting Diagram
NOTE Mounting the SE4750 in a non-upright position results in images rotated accordingly in snapshot or video
mode.
Notes: Unless otherwise specified:
• Chassis is at ground.
• Holes marked "A#" are engine locating aides.
Holes marked "B#" are threaded mounting holes.
Slot marked "C" is SE4750-SR LSR AIM specific locating aid.
• It is recommended to secure the engine using a combination
of two locating pins and two mounting screws which must
include A1 and B1.
• To ensure mounting compatibility with other engines in the
SE4500 and SE4750 families, the following is recommended:
• Allocate screw holes for A1, A3, A4
• Provide locating pins for B1, B2
• Do not use locating pins for C
• This is a reference drawing and is not intended to specify or
guarantee all possible integration requirements for this engine.
• All dimensions are in mm. All untoleranced dimensions follow a
general tolerance of +/- 0.15 mm.
To Next Page
Loading...
