6 - 10 SE4750 Integration Guide
Video Mode
Level/Auto-Aim Trigger Mode
The system is initialized as follows:
•
The host sends the Aim Off command.
•
The host sends the Illumination Off command.
•
The host sends the Acquisition Stop command.
•
The host sends the Imaging mode command.
•
The SE4750 optimizes the image output for video.
•
The SE4750 (typically) enters low power mode.
Upon a trigger pull:
•
The host sends the Illumination On command.
•
The SE4750, if in low power mode, exits low power mode (either Reduced or Sleep).
•
The host sends the Aim On command.
•
The host sends the Acquisition Start command.
•
The SE4750 begins outputting video stream.
Upon a trigger release:
•
The host sends the Acquisition Stop command.
•
The SE4750 stops outputting the video stream.
•
The host sends the Aim Off command.
•
The host sends the Illumination Off command.
•
The SE4750 (when all conditions are met) enters Reduced Power mode.
Recommendations
Power Mode
The SE4750 powers up into full power mode. To save power, enable AUTO_POWER_REDUCTION.
Scripts
For improved performance and timing synchronization, replace a set of discrete commands with a multi-command
EXECUTE-SCRIPT.
To Next Page
Loading...
