Motorola Symbol DS9808 - Appendix A Standard Default Parameters

Appendix A Standard Default Parameters
Table A-1 Standard Default Parameters Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Set Defaults 4-5
Parameter Bar Code Scanning ECh Enable 4-6
Beep After Good Decode 38h Enable 4-6
Beeper Tone 91h Medium 4-7
Beeper Volume 8Ch High 4-8
Beeper Duration F1h 74h Medium 4-9
Suppress Power-up Beeps F1h D1h Do not suppress 4-9
Hands-Free Mode F1h 76h Enable 4-10
Presentation Performance Mode F1h 8Ah Standard 4-11
Time Delay to Presentation Idle Mode F1h 97h 1 Minute 4-13
Time Delay to Presentation Sleep Mode F1h 96h 1 Hour 4-15
Low Power Mode 80h Disable 4-17
Time Delay to Low Power Mode 92h 1 Hour 4-18
Hand-Held Trigger Mode 8Ah Auto Aim 4-20
Multifunction Triggering (DS9808-LR/LL Only) Single Trigger 4-21
Trigger A F1h 77h Laser Preferred Decoding 4-22
Trigger B F1h 78h Trigger A value 4-23
1
User selection is required to configure this interface and this is the most common selection.